Asphalt Roofing
Found 6 free book(s)The Environmental Impact of Asphalt Plants
www.asphaltpavement.orgasphalt pavements, including rubber from used tires, glass, asphalt roofing shingles, and blast furnace slag. Recycling of asphalt pavement and asphalt roofing shingles conserves more than 21 million barrels of liq-uid asphalt binder annually. Busy Places and Controlled Traffic Although asphalt plants don’t take up a large amount
Oakridge Data Sheet - Atlanta, Memphis, Savannah
www.owenscorning.com§ 2018 Roofing Brand Awareness Study by Owens Corning Roofing and Asphalt, LLC. nternational Code Council Evaluation Services Acceptance Criteria for Alternative # I Asphalt Shingles. xcludes non-Owens Corning^ E ® roofing products such as flashing, fasteners, pipe . boots and wood decking.
UL Evaluation Report - Roofing Shingles & Materials | GAF
www.gaf.comSub-level 2: 07 30 00 – Steep Slope Roofing Sub-level 3: 07 31 00 – Shingles and Shakes Sub-level 4: 07 31 13 – Asphalt Shingle COMPANY: GAF 1 Campus Drive Parsippany, NJ 07054 (800) 766-3411 TechnicalQuestions@gaf.com www.GAF.com 1. SUBJECT: Asphalt Shingles Timberline® HDZ™, Timberline® AH, Timberline® CS 2. SCOPE OF EVALUATION
Metal Roofing and Siding Installation Guide
www.ascbp.com3 . Cover the entire roof deck with a minimum of 30 lb asphalt-saturated felt paper . Some synthetic underlayments may be used in place of felt with ASC Building Products’ roofing . Installer must ensure they meet the minimum standards of 30 lb felt and that the underlayment manufacturer has approved them for use with metal roofing .
ALLOWABLE SPANS FOR DF #1 HEADERS
dpw.lacounty.govLight Dead Load (up to 15 psf)/ Max. Roofing Load: 6 psf (Asphalt Shingles) ALLOWABLE SPANS FOR DF #2 CEILING JOISTS 2X6. Created Date: 12/1/2009 3:08:29 PM ...
12/15/2020 Florida Building Code Online - GAF
www.gaf.comAsphalt Shingles Royal Sovereign® Fiberglass reinforced, 3-tab asphalt roof shingle Loss on heating ASTM D228 max. 1.5% CA, FL, GA, IN, PA, TX Sliding on heating max. 1/16-inch Tear strength ASTM D1922 per D228 min. 3.75 lbs Penetration, asphalt ASTM D5 min. 15 Softening point, asphalt ASTM D36 190 <°F 320 Fastener pull-through resistance