PESD1CAN-U CAN bus ESD protection diode

ESD TESTER IEC 61000-4-2 network Cs = 150 pF; Rd = 330 Ω 4 GHz DIGITAL OSCILLOSCOPE 10x ATTENUATOR unclamped +8 kV ESD pulse waveform (IEC 61000-4-2 network) unclamped -8 kV ESD pulse waveform (IEC 61000-4-2 network) GND clamped +8 kV ESD pulse waveform (IEC 61000-4-2 network) aaa-007017 GND clamped -8 kV ESD pulse waveform (IEC 61000-4-2 network)

  Protection, Diode, Esd protection diodes, Kv esd

PESD1CAN CAN bus ESD protection diode

ESD clamping test setup and waveforms 006aaa259 50 Ω RZ CZ D.U.T. (Device Under Test) vertical scale = 200 V/div horizontal scale = 50 ns/div unclamped +1 kV ESD voltage waveform (IEC 61000-4-2 network) clamped +1 kV ESD voltage waveform (IEC 61000-4-2 network) unclamped −1 kV ESD voltage waveform (IEC 61000-4-2 network) clamped −1 kV ESD ...

  Kv esd

Description Pin Assignments - Diodes Incorporated

ESD HBM Human Body Model ESD Protection 2 KV ESD CDM Charged Device Model ESD Protection 1 KV ESD MM Machine Model ESD Protection 200 V V. CC (A), V. CC (B) Supply Voltage Range -0.5 to +6.5 V V. I. Input Voltage Range -0.5 to +6.5 . V : V. O. Voltage Applied to Output in High Impedance or I.

  Descriptions, Kv esd

IP4220CZ6 Dual USB 2.0 integrated ESD protection

ElectroStatic Discharge (ESD). It incorporates four pairs of ultra low capacitance rail-to-rail ESD protection diodes plus a Zener diode to provide protection to signal and supply components from ESD voltages up to 8 kV contact discharge. Protection is supply voltage independent due to the rail-to-rail diodes being connected to the Zener diode.

  Discharge, Electrostatic, Electrostatic discharge

EdgeRouter X Datasheet

ESD/EMP Protection Air: ± 24 kV, Contact: ± 24 kV Operating Temperature -10 to 45° C (14 to 113° F) Operating Humidity 10 to 90% Noncondensing Networking Interfaces Data/PoE Output Port (5) 10/100/1000 RJ45 Ports Data Port (1) 100/1000 SFP Port PoE with 24VDC Power Adapter PoE Out Voltage Range 22‑24VDC Max. PoE Wattage Per Data/PoE ...

UniFi PoE Switch Datasheet

ESD/EMP Protection Air: ± 24 kV, Contact: ± 24 kV Shock and Vibration ETSI300-019-1.4 Standard Operating Temperature -5 to 40° C (23 to 104° F) Operating Humidity 5 to 95% Noncondensing Certifications CE, FCC, IC

  Datasheet

ESDサプレッサ EZAEG タイプ - Panasonic

ピーク電圧 500 V 以下 IEC61000-4-2、接触放電8 kV、ピーク電圧値 ... ④ Gbpsレベルの高速差動信号回路やGHz以上高周波回路のESD対策に適した部品のため、電源回路のESD対策でのご使 …

ESDサプレッサ EZAEG タイプ EZAEG 1N, 2N シリーズ

esd耐量が大きい (iec61000-4-2, 15 kv接触／気中放電) 高速伝送ラインのesd対策部品に適している 静電容量が低い (1005サイズ：0.05 pf、 0603サイズ：0.04 pf)

FSA2567 - Low-Power, Dual SIM Card Analog Switch

ESD Human Body Model, JEDEC: JESD22−A114 All Pins − 3 kV I/O to GND − 12 Charged Device Model, JEDEC: JESD22−C101 − 2 Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. 1.

SRV05-4 ESD Protection Diode Array - ON Semiconductor

for ESD Devices. ESD Voltage Clamping For sensitive circuit elements it is important to limit the voltage that an IC will be exposed to during an ESD event to as low a voltage as possible. The ESD clamping voltage is the voltage drop across the ESD protection diode during an ESD event per the IEC61000−4−2 waveform. Since the

TXS0108E 8-Bit Bi-directional, Level-Shifting, Voltage ...

• IEC 61000-4-2 ESD (B port) – ±8 kV contact discharge – ±6 kV Air-gap discharge 2 Applications • Handsets • Smartphones • Tablets • Desktop PCs 3 Description This device is an 8-bit non-inverting level translator that uses two separate configurable power-supply rails.

Surface-Mount ESD Protection Diodes

ESD immunity Contact discharge acc. IEC 61000-4-2; 10 pulses VESD ± 30 kV Air discharge acc. IEC 61000-4-2; 10 pulses ± 30 kV Thermal resistance Mounted on epoxy glass PCB with 3 mm x 3 mm, Cu pads ( ≥ 40 μm thick) RthJA 180 K/W Forward clamping voltage IF = 50A, tp = 400 μs VF 2.5 V Junction temperature TJ 175 °C