Command Line Interface (CLI) Commands

← Back to document page

A-1Cisco TelePresence Multipoint Switch Release Administrator s GuideOL-12586-03APPENDIXACommand line Interface (CLI) CommandsInitial Release: February 25, 2009, OL-12586-03NoteFor the most complete version of the CTMS CLI Commands , see the online version of the CTMS Release Administration Guide at the following URL: of Contents Introduction section on page A-1 Starting a CLI Session section on page A-1 CLI Command Basics section on page A-2 Ending a CLI Session section on page A-2 CTMS CLI Commands section on page A-2IntroductionThis chapter explains how to use cisco TelePresence Multipoint Switch (CTMS) Command line Interface (CLI) a CLI SessionYou can access the CTMS CLI through the physical console or remotely.

Appendix A Command Line Interface (CLI) Commands Ending a CLI Session Note The admin ID and password can be changed from the default in the Cisco Unified Communications Manager (Unified CM) for CTMS device page. To start a CLI session: Step 1 From a remote system, use SSH to connect securely to CTMS. In the SSH client, enter the following

  System, Cisco, Line, Interface, Command, Command line interface