Command Line Interface (CLI) Commands - Cisco

← Back to document page

A-1Cisco TelePresence Multipoint Switch Release Administrator s GuideOL-12586-03APPENDIXACommand line Interface (CLI) CommandsInitial Release: February 25, 2009, OL-12586-03NoteFor the most complete version of the CTMS CLI Commands , see the online version of the CTMS Release Administration Guide at the following URL: of Contents Introduction section on page A-1 Starting a CLI Session section on page A-1 CLI Command Basics section on page A-2 Ending a CLI Session section on page A-2 CTMS CLI Commands section on page A-2IntroductionThis chapter explains how to use Cisco TelePresence Multipoint Switch (CTMS) Command line Interface (CLI) a CLI SessionYou can access the CTMS CLI through the physical console or remotely.

† set network gateway, page A-51 † set network hostname, page A-52 † set network ip eth0, page A-53 † set network max_ip_conntrack, page A-54 † set network mtu, page A-55 † set password admin, page A-56 † set rtpsleep, page A-57 † set snmp trapdest add, page A-58 † set snmp trapdest del, page A-59 † set snmp user add, page A-60

  User, Cisco, Line, Interface, Command, Getaways, Command line interface