COMPRESSOR REPLACEMENT PROCEDURE - Bard HVAC

← Back to document page

COMPRESSOR REPLACEMENTPROCEDUREManual No.:2100-003ESupersedes2100-003DFile:Vol ume I, Tab 1Date:06-25-02Bard Manufacturing CompanyBryan, Ohio 43506Since ahead just as planned Copyright 2002General InformationThree Phase Scroll CompressorStart Information ........................................ ............. 1Steps to Replace COMPRESSOR ................................ 1Suction and Discharge Tube Brazing ..................... 2Conclusion ........................................ ...................... 4iCONTENTSTablesTable 1 Air Contitioner Liquid LineFilter Driers (Directional).

compressor was not rotating. Contaminants are, therefore, largely confined to the compressor housing and a single installation of liquid and suction line filter-driers will probably suffice to clean up the system. E. If the sludge is evident in the discharge line (and very likely also found in the suction line) the compressor motor burned while ...

  Compressor, Procedures, Replacement, Compressor replacement procedure