Drafting - Engineering

← Back to document page

DraftingNATIONAL INSTITUTE FOR AVIATION RESEARCHWichita State UniversityRevision 2005. All rights of this material may be reproduced, used or disclosed, in part or in whole, without the expressed written permission of:National Institute for Aviation ResearchWichita State UniversityWichita, KSCopyright 2005. All rights DraftingCATIA V5R14Table of Contents, Page i Wichita State UniversityTABLE OF ........................................ ...................2DrawingScreen ........................................ .............3Pull-downMenus ........................................ ............4File ........................................ .................4Edit ........................................ .................5View.

CATIA Drafting CATIA® V5R14 Creating Views, Page 24 ©Wichita State University Front View The first view created is normally the front view. You can create a front view by defining the 3D object that you want to use and defining the plane that should be used to define the

  Catia