EQ6-R Mount

← Back to document page

EQ6-R MountEQ6-R-S-31091815V1-EN2PART I : SETTING UP THE EQ6-R MOUNTPART II : USING THE EQ6-R MOUNTPART III : POLAR ALIGNMENT PART IV : ELECTRONIC CONTROL INTERFACEPART V : OTHER EQ6-R Mount FEATURESAPPENDIX I : Setting Up the Tripod ........................................ ........................................ ............... Putting On the EQ6-R Mount ........................................ .................................... Attaching the Accessory Tray and the Hand Controller Holder ............................... Installing the Counterweights.

Lock Loosen Locking Knob Thumb Screw. 6 2. Release the Dec. clutch knob and rotate the Dec. axis until the two knobs on the dual-fit saddle are facing upward and the dovetail groove is leveled. Tighten the Dec. clutch again. Fig. 1.5 3. Loosen the two knobs on the saddle until the width of one of the dovetail grooves is slightly

  Locks, Eq6 r