FlexConnect - Cisco

← Back to document page

CHAPTER 7-1Enterprise Mobility Design Guide7FlexConnectFlexConnect (previously known as Hybrid Remote Edge Access Point or H-REAP) is a wireless solution for branch office and remote office deployments. It enables you to configure and control access points in a branch or remote office from the corporate office through a wide area network (WAN) link without the deployment of a controller in each office. The FlexConnect access points (APs) can switch client data traffic locally and perform client authentication locally. When they are connected to the controller, they can also send traffic back to the controller. Figure 7-1FlexConnect Architecture NoteTo view the FlexConnect feature matrix, see: #matrix 7-2Enterprise Mobility Design Guide Chapter 7 FlexConnectFlexConnect TerminologySupported PlatformsFlexConnect is only supported on these components: Cisco AP-1130, AP-1240, AP-1040, AP-1140, AP-1260, AP-1250, AP-3500, AP-1600, AP-2600, AP-3600, AP-3700, AP-1700, AP-2700, AP 700, AP-1520, AP-1530, AP-1550, AP-1570 access points Cisco 5520, 8540, Flex 7500, Cisco 8500.

in a branch or remote office from the corporate of fice through a wide area network (WAN) link without the deployment of a controller in each office. The FlexConnect access poin ts (APs) can switch client data traffic locally and perform client au thentication locally. When they ar e connected to the controller, they

  Network, Cisco, Area, Wide, Wide area network, Flexconnect