GEAR COUPLINGGEAR COUPLING - PowerDrive

← Back to document page

gear COUPLINGGEAR COUPLINGOrder Today ! Phone / Fax / Visit / COUPLINGSelection ProcedureTABLE 1 Torque and Horsepower RatingsSTANDARD SELECTION METHODThe standard selection method can be used for most motor,turbine, or engine driven applications. The following informationis required to select a gear or torqueRunning or type of equipment to be connectedpump, drive to conveyor, etc.).Shaft space limitationsSpecial bore or finish information and type of fit:Determine system torque. If torque is not given,calculate as shown Torque (lb - in) = HP x 63,000RPMWhere: HP (Horsepower) is the actual or transmitted powerrequired by the application (if unknown, use the motor or turbinenameplate rating) and RPM is the actual speed the COUPLING isrotating.

Service factors listed are typical values based on normal operation of the drive systems. Alphabetical listing of applications Alphabetical listing of industries Service Service Factor Factor Service Service Factor Factor AGGREGATE PROCESSING, CEMENT, MINING KILNS; TUBE, ROD AND BALL MILLS DirectoronL.S.shaftof Reducer, with final drive ...

  System, Gear, Coupling, Gear couplinggear coupling, Couplinggear