General tolerances

← Back to document page

BRITISH STANDARDBS EN22768-2:1993ISO 2768-2:1989General tolerances Part 2: Geometrical tolerances for features without individual tolerance indicationsThe European Standard EN 22768-2:1993 has the status of aBritish StandardUDC Copy: London South Bank University, London South Bank University, Wed Mar 15 03:46:41 GMT 2006, Uncontrolled Copy, (c) BSIBSEN22768-2:1993This British Standard, having been prepared under the direction of the Machine, Engineers and Hand Tools Standards Policy Committee, was published under the authority of the Standards Board and comes into effect on15 July 1993 BSI 03-1999The following BSI references relate to the work on this standard:Committee reference MTE/24 Draft for comment 87/78364 DCISBN 0 580 21934 8Cooperating organizationsThe European Committee for Standardization (CEN), under whose supervision this European Standard was prepared, comprises the national standards organizations of the follo

This part of ISO 2768 is intended to simplify drawing indications and specifies general geometrical tolerances to control those features on the drawing which have no respective individual indication. It specifies general geometrical tolerances in three tolerance classes. This part of ISO 2768 mainly applies to features

  Tolerance, 2876, Iso 2768