Installation and Setup Guide - Lennox

← Back to document page

Installation and SetupGuideColor TouchscreenProgrammable ThermostatComfortSense 7500 (13H14)2Table of ContentsShipping and Packing 7500 InstallationMounting SettingsMenu (Installer Settings) Part (Catalog) and Serial A. Flow B. Diagnostic C. Supported D. Installer and Packing List1 - ComfortSense 7500 touchscreen, 7-dayprogrammable thermostat and back plate2 - Mounting screws ( self-tappingscrews)2 -Wall anchors1 -Wall plate1 - Warranty certificate1 each - Homeowner and Installer GuidesNOTE - This thermostat is equipped withautomatic compressor protection to preventpotential damage due to short cycling or extendedpower outages.

the installation instruction for the dehumidifier. 1. Connect wiring between thermostat, indoor unit, and outdoor unit as shown in the appropriate wiring diagram. 2. Connect the outdoor sensor (if used) to the T connections on the thermostat (wire run should not exceed 300' [100m]). 3. Seal the hole in the wall with a suitable

  Installation, Instructions, Installation instructions, Lennox