INSTALLATION INSTRUCTIONS - American …

← Back to document page

Place back-up nuts on both bottom bolts, andthe top left-hand bolt the two lower back-up nuts so that frontface of nuts is flush with finished waste horn to project 5/16" fromfinished a level, adjust the top left back-up nut so thatit is in the same vertical plane as the lower left back-upnut. (If wall surface is irregular, the three back-upnuts must be positioned to allow a minimum 1/16"gap between fixture and wall surface.)NOTE: Bearing nuts and washers must be setto take full loading from the fixture allowing1/16" clearance between fixture and support manufacturer's recommendedsetting of closet outlet felt or neoprene gasket (wax ring notrecommended) on closet the fixture is installed, closet outletgasket must be compressed sufficiently toassure a gas and watertight bowl on support using cap nuts and fiberwashers with the back-up nuts and NOT APPLY TOP RIGHT FIBER WASHERAND CAP NUT UNTIL OTHER CAP NUTSHAVE BEEN FIRMLY TIGHTENED USING top right cap nut with fiber washer andrun up hand tight.

the top left-hand bolt only. Adjust the two lower back-up nuts so that front face of nuts is flush with finished wall. Refer to instructions supplied with

  American, Installation, Instructions, Installation instructions