interface port-channel - Cisco

← Back to document page

Chapter 2Cisco IOS Commands for the Catalyst 4500 series Switchesinterface port-channel2-107Catalyst 4500 series Switch Cisco IOS Command Reference Release (18)EW78-16201-0122interface port-channelTo access or create a port channel interface , use the interface port-channel command. interface port-channel channel-groupSyntax DescriptionDefaultsThis command has no default ModesGlobal configuration Command HistoryUsage GuidelinesYou do not have to create a port channel interface before assigning a physical interface to a channel group. A port channel interface is created automatically when the channel group gets its first physical interface , if it is not already can also create port channels by entering the interface port-channel command. This will create a Layer 3 port channel. To change the Layer 3 port channel into a Layer 2 port channel, use the switchport command before you assign physical interfaces to the channel group. A port channel cannot be changed from Layer 3 to Layer 2 or vice versa when it contains member one port channel in a channel group is Layer 3 port channel interface is the routed interface .

Catalyst 4500 Series Switch Cisco IOS Command Reference—Release 12.2(18)EW 78-16201-01 Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches interface vlan interface vlan To create or access a Layer 3 switch virtual interface (SVI), use the interface vlan command. To delete an SVI, use the no form of this command. interface vlan ...

  Series, Cisco, 4500, Switches, Catalysts, Catalyst 4500 series, Catalyst 4500 series switches