Interface Products Design Guide Using CAN, LIN …

← Back to document page

Interface Products Design GuideUsing CAN, LIN and infrared ConnectivityAnalog and Interface product SolutionsLIN TransceiverMCP201 General Purpose I/O ExpanderMCP23016MicrocontrollersPIC12F67 5PIC18F6680Stand-alone CAN ControllerMCP2515CAN TransceiverMCP2551CAN I/O ExpanderMCP250xxDesign ideas in this Guide are based on many of the Interface devices available from Microchip Technology. A complete device list and corresponding data sheets for these Products can be found at Encoder/DecoderMCP2120IrDA Protocol HandlerMCP2140MCP215x2 Interface Products Design Guide Interface Products Design Guide 3 product specifications can be found on page 10Controller Area Network (CAN)MCP2515 Stand-alone CAN Controller Features:n Implements CAN at 1Mb/sn Masks and filters to filter out unwanted messagesn Two receive buffersn Three transmit buffersn High speed SPI Interface (10 MHz)n Low voltage operation ( V V)n One shot mode to ensure a message transmission is only attempted oncen Start-of-frame (SOF) signal pin to detect CAN start-of-frameCAN Design Example: Simple Sensor NodeSimple Sensor Node Using MCP2515 Stand-alone CAN ControllerThe CAN bus (Controller Area Network) protocol was designed to be a high-speed, reliable communication protocol for command and control network applications.

Interface Products Design Guide Using CAN, LIN and Infrared Connectivity Analog and Interface Product Solutions LIN Transceiver MCP201 General Purpose I/O Expander

  Guide, Product, Using, Design, Interface, Infrared, Interface products design guide using