Interface Products Design Guide Using CAN, LIN …

← Back to document page

Interface Products Design GuideUsing CAN, LIN and Infrared ConnectivityAnalog and Interface product SolutionsLIN TransceiverMCP201 General Purpose I/O ExpanderMCP23016MicrocontrollersPIC12F67 5PIC18F6680Stand-alone CAN ControllerMCP2515CAN TransceiverMCP2551CAN I/O ExpanderMCP250xxDesign ideas in this Guide are based on many of the Interface devices available from Microchip Technology. A complete device list and corresponding data sheets for these Products can be found at Encoder/DecoderMCP2120IrDA Protocol HandlerMCP2140MCP215x2 Interface Products Design Guide Interface Products Design Guide 3 product specifications can be found on page 10Controller area network (CAN)MCP2515 Stand-alone CAN controller Features:n Implements CAN at 1Mb/sn Masks and filters to filter out unwanted messagesn Two receive buffersn Three transmit buffersn High speed SPI Interface (10 MHz)n Low voltage operation ( V V)n One shot mode to ensure a message transmission is only attempted onc

2 Interface Products Design Guide Interface Products Design Guide 3 Product specifications can be found on page 10 Controller Area Network (CAN)

  Guide, Controller, Product, Network, Using, Design, Area, Interface, Controller area network, Interface products design guide using can