Laminating problems and solutions - mactac.eu
Technical Bulletin Laminating problems & solutions Page 1 of 3 TECHNICAL BULLETIN - V2-September 2012 Laminating problems and solutions issues: Few laminator problems look worse than bubbles under the film. Bubbles are caused by a lot of problems : insufficient tension on the supply roll; feeding the leading edge of the print too quickly into the laminator; too much heat on a wet print, causing "outgassing" of the ink; the adhesive not bonding properly to the media, and others. Insufficient tension causes bubbles when air gets trapped between the film and image because the film wasn't taut as it entered the nib (caused by lack of supply roll tension).
Technical Bulletin 7.8 – Laminating problems & solutions Page 3 of 3 types of film. For instance, if he applies the same tension to both the top and bottom film, the
Download Laminating problems and solutions - mactac.eu
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Chemistry Formula Sheet Solving numerical, Chemistry Formula Sheet Solving numerical problems, ICRN 23 IAPWS Certified Research Need - ICRN, IAPWS Certified Research Need - ICRN, Interpreting Word Problems, Word Problems, Similar figures, Laptop Projection Resolution/Display Problems, Two-Word Utterances, Managing gender pay reporting, Problems, LOAD SHARING OF