Microsquirt Hardware Manual - EFI Source

← Back to document page

Microsquirt Hardware ManualMegasquirt-2 Product RangeMS2/Extra : 2015-03-14Hardware Manual covering specific wiring and configuration of your Microsquirt version of the documentation applies to: Microsquirt V3 as shown above running firmware MS2/Extra not apply to other Megasquirt products or other firmware versions.(c) 2014 James MurrayMicrosquirt Hardware GuideTable of Chapters1 Microsquirt System Fuel Ignition System - Ignition system - specific operating Optional Example Further Appendix A Appendix B: Junkyard guide to finding Revision (c) 2014 James Murray2015-03-14Page 2/ 154Microsquirt Hardware GuideContents1 Emissions and Required How to use this Microsquirt System Microsquirt Wiring Harness and Crank / Cam Sensor Tuning Best Wire and connector Soldering or Re-pinning Making the Four-pin relay pin-out Relay and accessory power Grounding (Earthing)

Microsquirt Hardware Guide 1 Introduction The Microsquirt is a compact ECU based on Megasquirt-2 technology. This manual covers Microsquirt specific installation details and should be used in conjunction with the general Setting up and TunerStudio reference manuals. 1.1 Emissions and disclaimer

  Manual, Hardware, Microsquirt hardware manual, Microsquirt, Microsquirt hardware