MODULE 1c STRUCTURAL ENGINEERING SYSTEMS PART …

← Back to document page

FEMA NATIONAL US&R RESPONSE SYSTEMSTRUCTURAL COLLAPSE TECHNICIAN TRAINING MANUAL 02-00MODULE 1c STRUCTURAL ENGINEERING SYSTEMSPART 1. building MATERIALS & STRUCTURAL SYSTEMS SM 1c, 1&2 1In this introductory section our Objectives are as listed in theadjacent slides. We will quickly review the basics of how variousbuilding materials resist forces, the importance of Ductile behavior, the concepts of Vertical and Lateral LoadResisting SYSTEMS , and STRUCTURAL TYPESIndividual LOADS, usually referred to as FORCES can be dividedinto four types: Tension. Compression, Bending, and When a FORCE is applied to an individual member, itproduces STRESSES, which are defined as the FORCEdivided by the cross-sectional area on which it Example: If a 1000lb FORCE acting in Tension on a 2 inch x2 inch steel bar, will produces a 250 lbs per square inch (psi)Tension For simplicity we will we will discuss the effects of FORCES,and assume that the student understands the relationshipbetween F

STRUCTURAL COLLAPSE TECHNICIAN TRAINING MANUAL 02-00 MODULE 1c STRUCTURAL ENGINEERING SYSTEMS PART 1. BUILDING MATERIALS & STRUCTURAL SYSTEMS SM 1c, 1&2 2 TENSION FORCES (continued) • Ductile behavior is the ability of a material to stretch and/or bend without suddenly breaking, and after the load

  System, Engineering, Material, Building, Part, Structural, Module, Module 1c structural engineering systems part, Module 1c structural engineering systems part 1, Building materials amp structural systems