PM0075 Programming manual - STMicroelectronics
August 2012Doc ID 17863 Rev 21/31PM0075Programming manualSTM32F10xxx Flash memory microcontrollersIntroductionThis Programming manual describes how to program the Flash memory of STM32F101xx, STM32F102xx, STM32F103xx, STM32F105xx and STM32F107xx microcontrollers. For convenience, these will be referred to as STM32F10xxx in the rest of this document unless otherwise STM32F10xxx embedded Flash memory can be programmed using in-circuit Programming or in-application in-circuit Programming (ICP) method is used to update the entire contents of the Flash memory, using the JTAG, SWD protocol or the boot loader to load the user application into the microcontroller. ICP offers quick and efficient design iterations and eliminates unnecessary package handling or socketing of devices.
Table 5. Flash module organization (connectivity line devices) The Flash memory is organized as 32-bit wide memory cells that can be used for storing both code and data constants. The Flash module is located at a specific base address in the memory map of each STM32F10xxx microcontroller type. For the base address, please
Download PM0075 Programming manual - STMicroelectronics
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: