POINT I/O Field Potential Distributor Modules

← Back to document page

Installation InstructionsPOINT I/O Field Potential Distributor ModulesCatalog Numbers 1734-FPD, 1734-FPDK, Series BCatalog numbers with the suffix K are conformal coated and their specifications are the same as non-conformal coated of ContentsTopicPageImportant User Information 2Environment and Enclosure3Prevent Electrostatic Discharge3North American Hazardous Location Approval4European Hazardous Location Approval5Before You Begin7Install the Module8Remove the Module9Replace the Module9Wire the Module10Specifications132 POINT I/O Field Potential Distributor Modules Publication 1734-IN059G-EN-P - December 2018Important User InformationSolid-state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid-State Controls (Publication available from your local Rockwell Automation sales office or online at ) describes some important differences between solid-state equipment and hard-wired electromechanical devices.

ATEX directive 2014/34/EU. † May have catalog numbers followed by a “K” to indicate a conformal coating option. WARNING: Special Conditions for Safe Use: † This equipment is not resistant to sunlight or other sources of UV radiation. † This equipment shall be mounted in an ATEX/IECEx Zone 2 certified

  Directive, Texas, Iecex, Atex directive