Robotic Cleaner Troubleshooting Guide

← Back to document page

Copyright 2010 Hayward Industries Cleaner Troubleshooting Guide Table of ContentsTigerShark & TigerShark QCImportant safety instructionsPage 1Service ToolsPage 2Filter Removal/Cleaning and Drain FlapsPages 4-6Handle RemovalPage 7Venturi RemovalPage 8Bottom Lid DisassemblyPages 9-10Side Cover RemovalPages 11-12Drive Track and IdlersPages 13-16Power Cord and Motor BoxPages 17-27Wheel Tube Brush and BearingsPages 28-30Using the Scanner ToolPages 31-34Power Supply and Flotation Cord TestingPage 35Basic OperationPages 36-37TroubleshootingPages 38-43Table of Contents ContinuedSharkVAC & E-VacService ToolsPage 44Power SupplyPage 45Filter RemovalPages 46-47Filter ReplacementPage 48Wheel and Tire RemovalPage 49Side Cover Removal Page 50Drive Track and Idlers Page 51Main Drive Pulley RemovalPage 52Wheel Tube RemovalPage 53Wheel Tube BrushPage 54Power Cord RemovalPages 55-60Motor Box RemovalPages 61-62Power Supply and Flotation Cord TestingPage 63TroubleshootingPages 64-68Safety!

7. Worn or defective pump motor, drawing less than 1 amp at 24 volts. Number of times the pump motor has realized an over load condition. Unit will stop after 3-5 seconds in this condition. Pump Over Current Causes 1. Debris around the pump impeller. Remove impeller and inspect for hair or grass around pump shaft. 2. Defective pump motor.

  Pumps, Post