Sealmaster Mounted Bearing Engineering Guide

← Back to document page

Application Parameters:Shaft Speed in RPM:Desired Operating Life in Hours: Bearing Loads in Lbs.:Environments:WetRadial:ChemicalThru st:DirtyOtherOperating Temperature:-30 to 200 F *200 to 400 F-100 to -30 F * Bearing Type and Bore:Check Ball and Roller Bearing Pages Bore Size: Bearing Housing Page Seal Pages Selected:Felt SealContact Lock Pages Lock Selected:Single Lock Set ScrewDouble Lock Set ScrewSkwezloc (Ball Bearings Only)BEARINGSELECTIONGUIDE6. Refer to ........................................ ...................................... Pages 10-13For Ball Bearing Nomenclature and Pictorial index to locate to ........................................ ...................................... Pages 96-97For Roller Bearing Nomenclature and Pictorial index to locate Selected:7. For Application Parameters outside capabilities of selected *Contact Application Engineering (630-898-9620) or you can fax theApplication Worksheet on Page 207 to (630-898-6064).

Mounted ball bearings are typically “slip fitted” to the shaft and rely on design features such as the inner race length and locking device for support. ABMA recommends an a 3 factor of .456 for “slip fit” ball bearings.* Shock and Vibration* — Vibration and shock loading can act as an additional loading to the steady expected applied ...

  Mounted, Bearing