STANDARD OPERATING PROCEDURES for COMMON …

← Back to document page

[Type here] [Type here] [Type here] Faculty of Engineering Workshop Services STANDARD OPERATING PROCEDURES for COMMON tool & machining EQUIPMENT [Type here] [Type here] [Type here] The information in this booklet is provided as a guide for the minimum safety training that shall be provided to personnel prior to being authorized to use of any of the following machining tools or pieces of equipment: Mill, Lathe, Planer, Drill Press, Pedestal Grinder, & Band Saw. . GENERAL SAFETY TIPS Safety glasses with side shields must be worn at all times.

STANDARD OPERATING PROCEDURES for COMMON TOOL & MACHINING EQUIPMENT ... If frayed belts or pulleys are observed, the lathe must be taken out of service and the belts or pulleys replaced. • Stop the machine immediately if odd noise or excessive vibration occurs.

  Operating, Standards, Procedures, Tool, Common, Pulleys, Machining, Standard operating procedures for common, Standard operating procedures for common tool amp machining