117 10 Specification For Tolerances For Concrete
Found 8 free book(s)ACI 117-10 Specification for Tolerances for Concrete ...
www.concrete.orgSPECIFICATION COMMENTARY TOLERANCES FOR CONCRETE CONSTRUCTION 117-3 INTRODUCTION This commentary pertains to “Specifications for Tolerances for Concrete Construction and Materials (ACI 117-10).” The purpose of the commentary is to provide an illustrative and narrative complement to the specification; it is not a part of the specification.
117-06 Specifications for Tolerances for Concrete ...
dl.mycivil.irReported by ACI Committee 117 ACI 117-06 Specification synopsis: This specification provides standard tolerances for concrete construction. This document is intended to be used by specification writers and ACI committees writing standards as the reference document for establishing tolerances for concrete construction.
117-10: Specification for Tolerances for Concrete ...
www.dli.pa.govReported by ACI Committee 117 ACI 117-10 (Reapproved 2015) Specification synopsis: This specification provides standard tolerances for concrete construction and materials. This document is intended to be used by specification writers and ACI committees writing standards as the reference document for establishing tolerances for concrete construction
117-90 Standard Specifications for Tolerances for Concrete ...
lauwtjunnji.weebly.comSection 5 - Precast concrete, p. 117-10. 5.1 - Fabrication tolerances in linear elements except piles 5.2 - Fabrication tolerances for piles 5.3 - Fabrication tolerances in planar elements 5.4 - Erection tolerances. Section 6 - Masonry, p. 117-11. 6.1 - Vertical alignment 6.2 - Lateral alignment 6.3 - Level alignment
Data Sheet Tolerance for Concrete Surfaces
www.ccaa.com.auWhen specifying tolerances for concrete work, reference is often made to the Australian Standards/Specifications AS 360.11, AS 36005 and NATSPEC6. The relevant contents of these are outlined below. AS 3610.11 – Formwork for concrete This Standard deals with the visual quality (appearance) of formed concrete surfaces, for
Subsurface Tolerances and Floor Flatness Requirements — A ...
www.custombuildingproducts.comthe ACI 117 specification, as a way of determining the flatness (and levelness as per F/L numbers) of concrete slabs. F-numbers are determined through testing procedures in AStM e-1155. these testing procedures are also referenced in AStM F-710 for the Preparation of Concrete Floors to receive resilient Flooring. Determining the flatness of a
Technical Specification- Civil
www.sydneywater.com.auC3.5.7 Concrete aggregates not to contain asbestos. C8.5 Road base and sub-base materials not to contain asbestos. 5 C1.5 Recycled and Reuse Material clause amended. Table 3-1 Cement type for N class concrete amended. C3.11.2 Table 3-4 Concrete Curing Time inserted, and clause amended.
National Structural Concrete Specifi cation
www.engineeringsurveyor.com10.12 Precast concrete elements 34 110 Project Specification Section P1 Information to be supplied TO the Constructor 38 111 P1.1 General information 38 111 P1.2 Design 40 112 P1.3 Drawings and calculations 41 112 P1.4 Execution management 42 114 P1.5 Materials 44 115 P1.6 Project requirements 45 116 P1.7 Water-resisting construction 45 117 P1 ...