Cement Based Patching
Found 5 free book(s)Installation Guide - Fiber Cement Products
www.jameshardiepros.com• Avoid using resin, rosin or cement-coated fasteners that can discolor vinyl flooring. 2 | Patch • Use the cement-based, rapid-setting patching compound recommended by the floor covering manufacturer. • Do not use a gypsum-based patch. Follow the patch manufacturer’s instructions. Preparation for Underlayment
CONSTRUCTION SPECIFICATION FOR HOT MIX ASPHALT
www.walkerind.comPerformance Graded Asphalt Cement (PGAC) means an asphalt binder that is an asphalt-based cement produced from petroleum residue, either with or without the addition of non-particulate modifiers, according to AASHTO M320. Quality Assurance (QA) means a system or series of activities carried out by the Owner to ensure that
TM Underlayment and Tile Backerboard Installation Guide
www.usg.combe designed (based on stud properties alone) not to exceed L/360 deflection for tile, L/240 for surfaces that will be painted. Maximum fastener spacing: 8" o.c. for wood and steel framing; 6" o.c. for ceiling applications. – Patching Compound Use a high-quality patching compound such as USG Durock ™ Fast Finish Floor Patch or equivalent
Directive 020: Well Abandonment - Alberta Energy Regulator
static.aer.calevel-A interval), an additional cement plug must be circulated on top of the uppermost previously abandoned zone. This cement plug must be a minimum length of 30 vertical metres and have a minimum volume of 1 m 3. The base of this plug must be located below the base of groundwater protection ( BGWP).
MASTER SPECIFICATIONS Division 22 PLUMBING
www.northwestern.eduA. Refer to applicable Division 01 Section covering cutting and patching and applicable Division 02 Section covering selective structure demolition for general demolition requirements and procedures. B. If pipe, insulation, or equipment to remain is damaged in …