The Oscilloscope and the Function Generator

4. Set the controls of the function generator to produce a sine wave of about 1000 Hz frequency and a few volts amplitude. Depending on your generator, here’s how: ANALOG (Krohn-Hite, Wavetek, Exact) Use the \waveform" or \function" switch to select the sine (curvy-line) waveform type. Use the frequency adjust knob and multiplier button/switch

  Generators, Functions, Function generator

200 MHz Clock Generator PLL ADF4001 - Analog Devices

200 mhz clock generator pll functional block diagram rfina rfinb 13-bit n counter lock detect current setting 1 cpi3 cpi2 cpi1 cpi6 cpi5 cpi4 m3 m2 m1 sdout avdd refin clk data le avdd dvdd vp cpgnd rset 14-bit r counter r counter latch function latch 24-bit input register n counter latch sdout 22 14 adf4001 mux muxout high z setting 2 charge ...

  Devices, Generators, Functions, Analog devices, Analog

High-Frequency Waveform Generator

The MAX038 is a high-frequency, precision function generator producing accurate, high-frequency triangle, sawtooth, sine, square, and pulse waveforms with a minimum of external components. The output frequency can be controlled over a frequency range of 0.1Hz to 20MHz by an internal 2.5V bandgap voltage reference and an external resistor and ...

  Generators, Functions, Function generator

XR-2206

The XR-2206 is a monolithic function generator integrated circuit capable of producing high quality sine, square, triangle, ramp, and pulse waveforms of high-stability and accuracy. The output waveforms can be both amplitude and frequency modulated by an external voltage. Frequency of operation can be selected

  Generators, Functions, Function generator

E8257D PSG Microwave Analog Signal Generator

Feb 16, 2021 · Time from GPIB trigger to frequency within 0.1 ppm of final frequency above 250 MHz or within 100 Hz below 250 MHz. CW switching …

  Generators

Low Power, 8.5 mW, 2.3 V to 5.5 V, Programmable Waveform ...

with a 16 MHz clock rate, resolution of 0.06 Hz can be achieved; with a 5 MHz clock rate, the AD9837 can be tuned to 0.02 Hz resolution. The AD9837 is written to via a 3-wire serial interface. This serial with DSP and microcontroller standards. The device operates with a power supply from 2.3 V to 5.5 V. The AD9837 has a power-down (sleep ...

LPC546xx Product data sheet

12 MHz internal Free Running Oscillator (FRO). This oscillator provides a selectable 48 MHz or 96 MHz output, and a 12 MHz output (divided down from the selected higher frequency) that can be used as a system clock. The FRO is trimmed to 1 % accuracy over the entire voltage and temperature range.

DS STM32F42x 43x step2 - STMicroelectronics

83 MHz) • Chrom-ART Accelerator™ for enhanced graphic content creation (DMA2D) • Clock, reset and supply management – 1.7 V to 3.6 V application supply and I/Os – POR, PDR, PVD and BOR – 4-to-26 MHz crystal oscillator – Internal 16 MHz factory-trimmed RC (1% accuracy) – 32 kHz oscillator for RTC with calibration