Slip Type Valve
Found 5 free book(s)INS2153C - 6/14
assets.moen.comIf installing a slip-fit tub spout, connect to the valve with only copper tub-ing – no threaded adapter is needed. See step 4.3 for tub spout tube length. 2. Installation Schematics – ... support for the valve.Installations of this type require the plaster ground to remain attached to the valve. 1. Drill a 2-1/4 inch to 3-1/2 inch diameter
Pipe Fitters Handbook - pipe-valve-fitting.com
www.pipe-valve-fitting.comSlip the gasket over the pipe end making sure the gasket lip does not overhang the pipe end. On couplings 10" and larger it may be easier to turn the gasket inside out then lubricate and slide the gasket over the pipe end as shown. 3. Alignment After aligning the two pipe ends, pull the gasket into position centering it between the
Installation/ Operator Maintenance VariTrane™ Single-Duct ...
www.trane.comDigit 1, 2—Unit Type VC VariTrane single-duct Digit 3—Reheat C Cooling Only E Electric Heat W Hot Water Heat Digit 4—Development Sequence F Sixth Digit 5, 6—Primary Air Valve 04 4" inlet (225 cfm) 05 5" inlet (350 cfm) 06 6" inlet (500 cfm) 08 8" inlet (900 cfm) 10 10" inlet (1400 cfm) 12 12" inlet (2000 cfm) 14 14" inlet (3000 cfm) 16 ...
KEYSTONE BUTTERFLY VALVE PARASEAL RANGE
www.emerson.comKEYSTONE BUTTERFLY VALVE PARASEAL RANGE DN 50-2400 (2-96 INCH) 1. Top flange Conform to ISO 5211 standard, with integrated recess for accurate actuator installation. 2. Chevron seal This uniquely shaped shaft seal prevents environmental pollution to penetrate to the internals of the valve. 3. Bearings
MY21 Police Specs - Harley-Davidson
www.harley-davidson.com49 mm Dual Bending Valve Premium standard height hand-adjustable rear suspension Impeller Cast Aluminum 17 in. x 3 in. (432 mm x 76 mm) 16 in. x 5 in. (406 mm x 127 mm) Brakes 32 mm, 4-piston front and rear 11.8 in. x 0.2 in. (300 mm x 5.1 mm) 11.8 in. x 0.28 in. - Rear (300 mm x 7.1 mm) Standard 4.6 in. (117 mm) 3 in. (76 mm) Swingarm Front Fork