Transcription of 1-Wire Communication with PIC Microcontroller
{{id}} {{{paragraph}}}
Example: bachelor of science
1-Wire Communication with PIC Microcontroller
AN1199. 1-Wire Communication with PIC Microcontroller Author: Sashavalli Maniyar 1-Wire Protocol Microchip Technology Inc. The protocol is called 1-Wire because it uses 1 wire to transfer data. 1-Wire architecture uses a INTRODUCTION pull-up resistor to pull voltage off the data line at the master side. This application note introduces the user to the 1-Wire 1-Wire protocol uses CMOS/TTL logic and Communication protocol and describes how a 1-Wire operates at a supply voltage ranging from device can be interfaced to the PIC microcontrollers . to 6V. 1-Wire protocol is a registered trade mark of Maxim/ Master and slave can be receivers and Dallas Semiconductor. transmitters, but transfer only one direction at a A software stack for the basic, standard speed, 1-Wire time (half duplex).
AN1199 DS01199A-page 2 © 2008 Microchip Technology Inc. FIGURE 1: HARDWARE INTERFACE OPERATIONS OF THE 1-Wire BUS The four basic operations of a 1-Wire …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: