Installation Guide - James Hardie Pros

1 | English CUTTING CEMENT HARDIEBACKER® BOARD • Use a straight edge as a guide to score the board’s face and snap upward …

  Guide, Installation, Installation guide

HardieTrim Boards Products Description - James …

HardieTrim boards, /4! /4 HardieTrim 5/4, 4/4 boards that should get two ®

  Product, Descriptions, Board, Hardietrim boards products description, Hardietrim, Hardietrim boards

HardiePlank Lap Siding Product Description - …

General Product Information Tools for utting and Fastening General Installation Reuirements General Fastener Reuirements Finishing and aintenance

  Product, Descriptions, Siding, Lap siding product description

TR1509 HardieTrim HZ Installation ... - James Hardie …

joist 1 in. min. water resistive siding barrier flashing deck material ledger trim flashing FLASHING/CLEARANCE REQUIREMENTS NO-COVER vertical trim 1/4 in. min.

  James, Vertical, Siding, James hardie, Hardie

Fastening Tips for HardiePlank Lap Siding …

IMPORTANT: Failure to install and fi nish this product in accordance with applicable building codes and James Hardie written application instructions

  Tips, Fastening, Siding, Hardieplank, Fastening tips for hardieplank lap siding

Evaluation Report ESR 2290 - James Hardie Pros

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed

Evaluation Report ESR 1844 - Fiber Cement Products

ESR-1844 | Most Widely Accepted and Trusted Page 2 of 6 4.2 Installation: 4.2.1 General: 8The manufacturer’s published installation instructions and this report must be strictly adhered to and a copy of this report and the instructions must be available

  Evaluation, Cement

HardiePlank Lap Siding - James Hardie Pros

IMPORTANT: To prevent damage to the drip edge, extra care should be taken when removing planks from the pallet, while handling, and when installing with a lap gauge.

INSTALLATION INSTRUCTIONS - James Hardie Pros

Hardie. This document is intended for use by builders, cladding installers, and other contractors who may be involved with the installation of the Reveal Panel System. The Reveal PanelSystem by James Hardie provides a durable, expressed joint panel appearance for building facades offering versatility to architects and builders.

  Cladding

Exterior Wall Drainage Requirements - James Hardie Pros

a 3/8 inch air gap (i.e. rainscreen) between flat-to-wall siding and the water-resistive barrier as a best practice. James Hardie recommends that you consult with your design professional if you have questions regarding exterior wall drainage on your single-family project. Individual buildings All exterior cladding products, including hard siding,

  Cladding, Rainscreen

HOW TO CORRECTLY WATERPROOF TILED SHOWERS …

a tiled floor, laying a waterproof membrane across the entire floor and extending it up all walls for at least 150 mm is recommended. A waterstop (see Figure 4) should be provided where the membrane terminates at adjacent spaces such as doorways. If the substrate is a sand or cement mortar or screed, the waterproof membrane should be laid over ...

  Membrane, Correctly, Shower, Waterproof, Waterproof membrane, Tiled, How to correctly waterproof tiled showers

FLOOR AND AREA DRAINS - Watts

waterproof membrane structural slab cast iron drain body (push–on shown) soil stone waterproof membrane sub floor precast construction ductile iron grate secured with vandal proof screws heavy duty drain support flange gasket cast iron drain body (no hub shown) underdeck clamp (optional) fd-320-y-5-6 fd-900

  Membrane, Waterproof, Waterproof membrane

Custom Building Products RedGard Waterproofing and Crack ...

RedGard as General Waterproof Membrane (ANSI 118.10) Cracks to 1/8" (3 mm) should be prefilled before beginning the waterproofing application. Dampen all porous surfaces. Use a 3/4" (19 mm) rough textured synthetic roller or a 3/16" × 1/4" (5 × 6 mm) V-notch trowel and heavily precoat the corners and the intersections where the

  Membrane, Waterproof, Waterproof membrane

Schluter -Shower System Installation Handbook 2020

CONTENTS 4 6 Schluter®-KERDI waterproofing membrane 8 Schluter®-KERDI-BOARD waterproof building panel 10 Schluter®-DITRA-HEAT shower application 12 Curbless showers 16 Schluter®-KERDI waterproofing membrane and Schluter®-KERDI-BOARD waterproof building panel 18 Schluter®-KERDI-DS waterproofing membrane 20 Bathtub surround …

  Membrane, Waterproof, Schulter

Undrained Triaxial Compression Tests Laboratory Experiment ...

waterproof seal. 3. Place the soil specimen on the base, and place the cap on top of the specimen. Make sure that the piston hole in the cap faces up. 4. Place the membrane and two O-rings on the membrane stretcher, and apply light vacuum to the membrane stretcher tube to pull the membrane towards the inside wall of the membrane stretcher.

  Membrane, Waterproof

PREVENTING WATERPROOFING DEFECTS

The ability of a waterproofing membrane of the correct thickness to stretch without breaking, where it is not bonded to the substrate The classification of the membrane determines how to design the bond breakers at critical junctions The bond breaker design for each class of membrane allows for around 5mm of movement without detrimental effects.

  Membrane, Waterproofing, Defects, Waterproofing defects

Code of practice - Internal wet area membrane systems

Code of Practice for Internal Wet Area Membranes Page 6 of 108 Waterproofing Membrane Association NZ Inc, www.wmai.org.nz February, 2020 2.0.2 Household kitchen sinks and laundry tubs that have an integrated overflow with

  System, Internal, Area, Membrane, Internal wet area membrane systems

Waterproofing Membranes CCW MiraDRI 860/861

Barricoat-S Spray-Applied Waterproofing Membrane Barricoat is a water-based, asphalt emulsion modified with a blend of synthetic rubbers and special addi-tives. It cures rapidly to a mono-lithic, highly flexible membrane. For difficult to waterproof below grade substrates, Barricoat-S is the solution. Barricoat-S consists of a

  Membrane, Waterproof

Decking Over a Roof - Chief Architect

adhere the roofing membrane about 2 ft. up the sheathing and then counterflash with a self-adhering butyl membrane. I pulled back the existing building paper after stripping the siding, installed the butyl membrane, and lapped the building paper back over it. This proce-dure makes for a watertight connection on ordinary rainy days, but

  Roof, Membrane