Transcription of 12-Volt Negative Ground Installation Instructions
{{id}} {{{paragraph}}}
Example: air traffic controller
12-Volt Negative Ground Installation Instructions
12-Volt Negative Ground Installation InstructionsPage 1 of 4 CAUTION!!! Before installing, please read the following important Negative Ground Installation InstructionsPage 1 of 4 CAUTION!!! Before installing, please read the following important The Ignitor is designed for 12-Volt Negative Ground systems. 2. Leaving the ignition ON with the engine OFF for an extended period could result in permanent damage to the See Chart on back page for coil recommendations. 4. Four & Six cylinder engines require a minimum of ohms of primary resistance. Do not remove resistors if the coil primary resistance is less than ohms. 5. If your Ignition coil has the recommended primary resistance, remove or bypass all external resistors. 6. The Ignitor is compatible as a trigger for most electronic Negative Ground Installation InstructionsPage 1 of 4 For Part Number: 1244 ADISASSEMBLY1. PRIOR TO Installation TURN IGNITION SWITCH OFF OR DISCONNECT THE BATTERY 2.
12-Volt Negative Ground Installation Instructions Page 1 of 4 ATION Beore ta eae rea te oo mortat ormato 99-599-5955 www.pertronix.com 1. The Ignitor is designed for 12-olt negative ground systems.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: