Transcription of 12-Volt Negative Ground Installation Instructions
{{id}} {{{paragraph}}}
Example: bankruptcy
12-Volt Negative Ground Installation Instructions
CAUTION!!! Before installing, please read the following important !!! Before installing, please read the following important The Ignitor is designed for 12-Volt Negative Ground systems. 2. Leaving the ignition ON with the engine OFF for an extended period could result in permanent damage to the See Chart on back page for coil recommendations. 4. Four and six cylinder engines require a minimum of ohms of primary resistance and eight cylinder engines require a minimum of ohms of primary resistance. Do not remove resistors if the coil primary resistance is less than specified. 5. If your Ignition coil has the recommended primary resistance, remove or bypass all external resistors. 6. The Ignitor is compatible as a trigger for most electronic Negative Ground Installation InstructionsPage 1 of 4 For Part Number: 1141, 1164, 1165, 1181 DISASSEMBLY1. PRIOR TO Installation TURN IGNITION SWITCH OFF OR DISCONNECT THE BATTERY 2.
CAUTION!!! Before installing, please read the following important information.... 909-599-5955 www.pertronix.com 1. The Ignitor is designed for 12-Volt negative ground systems.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Healing Unseen Negative Influences[1, Ground, Vs. Negative, Facilitator Note, Scenario, Vs. Negative, Facilitator Note, Scenario Sheets, Negative, Generate a Negative Voltage Using Buck, Ground Moving Target, Noise Positive and Negative Output, Noise Positive and Negative Output Integrated, 1.0 A Negative Voltage Regulators