Transcription of 12-Volt Negative Ground Installation Instructions
{{id}} {{{paragraph}}}
Example: bankruptcy
12-Volt Negative Ground Installation Instructions
CAUTION!!! Before installing, please read the following important !!! Before installing, please read the following important The Ignitor is designed for 12-Volt Negative Ground systems. 2. Leaving the ignition ON with the engine OFF for an extended period could result in permanent damage to the See Chart on back page for coil recommendations. 4. Four and six cylinder engines require a minimum of ohms of primary resistance and eight cylinder engines require a minimum of ohms of primary resistance. Do not remove resistors if the coil primary resistance is less than specified.
COIL WIRE RED WIRE BLACK WIRE TO IGNITION COIL WIRE TO IGNITION SWITCH RED WIRE BLACK WIRE RESISTANCE WIRE BALLAST RESISTOR The Ignitor can also be installed in applications retaining the ballast resistor or resistance wire.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: