Transcription of 2. Now, Configure the Switch with the NETGEAR …
{{id}} {{{paragraph}}}
Example: air traffic controller
2. Now, Configure the Switch with the NETGEAR …
Page 1 Friday, July 23, 2010 3:09 PM. Next, Install the NETGEAR Device Manager Utility 3. Connect the Switch to your network. )NSTALLATION 'UIDE (Smart Control Center) on a PC 4. Power on the Switch . 5. Verify that the PC with the Smart Control Center utility is on the same subnet NETGEAR ProSafe 24 Port 10/100 PoE Smart Switch with 4 Gigabit Uplink as the Switch . Ports FS728 TPv2 1. Insert the Resource CD into your CD drive. 2. Run the Setup program to install the Smart Control Center utility. The start here Installation Wizard will guide you through the installation. Now, Configure the Switch with the NETGEAR . Device Manager Utility (Smart Control Center). Follow these instructions to set up your smart Switch . Before proceeding with the Next, Connect Your Smart Switch in the Correct smart Switch installation, familiarize yourself with the contents of the Resource Order 1.
)NSTALLATION'UIDE NETGEAR ProSafe 24 Port 10/100 PoE Smart Switch™ with 4 Gigabit Uplink Ports FS728TPv2 Start Here Follow these instructions to …
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: