PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: confidence

2015 Plumbing Rough In Checklist - MyBuildingPermit

inspection Checklist Residential Plumbing Rough In July 2016 This inspection Checklist reflects code requirements of the 2015 International Residential Code (IRC), 2015 Uniform Plumbing Code (UPC), 2014 National Electrical Code (NEC), and the 2015 International Fire Code (IFC). GENERAL INFORMATION: This Checklist is intended for use to prepare for an inspection . This is only a general list and is not intended to address all possible conditions. Additional information can be obtained from your local participating jurisdiction. Page 1 of 6 Please verify the following before calling for a Plumbing Rough -in inspection . Permits and Plans Job address is posted in a visible location. (IRC ) Permit and approved plans are on site and accessible to the inspector. (Amend. Ord.) Permit information is correct.

This Inspection Checklist reflects code requirements of the 2015 International Residential Code (IRC), 2015 Uniform Plumbing Code (UPC), 2014 National Electrical Code (NEC), and the 2015 International Fire Code (IFC). GENERAL INFORMATION: • This checklist is intended for use to prepare for an inspection. This is only a general list and is not

Fullscreen Download

Tags:

  Checklist, 2015, Inspection, Inspection checklist

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Transcription of 2015 Plumbing Rough In Checklist - MyBuildingPermit

Documents from same domain

Inspection Checklist Residential Fuel ... - MyBuildingPermit

mybuildingpermit.com

a building if sleeved in schedule 40 steel, iron, or plastic pipe conduit extending at least 4 inches to outside of building. (G2415.14) The interior end of the conduit enclosing the gas pipe is sealed. (G2415.14.1) The exterior end of the conduit is a minimum 4 inches outside of the building, vented above grade and

  Schedule

INSPECTION CHECKLIST Residential Re-roof

mybuildingpermit.com

When the application of new roof covering over wood shingle or shake roofs creates a combustible concealed space, the entire existing surface is to be covered with gypsum board, mineral fiber, glass fiber or other approved material and securely fastened in place. (R908.4)

  Applications, Checklist, Material, Residential, Roof, Inspection, Woods, Inspection checklist residential re roof

Converting a Garage to Living Space - Welcome to MBP | MBP

mybuildingpermit.com

opening. In these cases it is often required to dig under the slab and add a footing to support the new wall above. The figure to the right shows one way that can be done. For other options speak to your jurisdiction. Excavation may be required to verify the existing slab thickness. Energy Code Requirements If your project does not meet the ...

  Excavations, To dig

Residential Building Final

mybuildingpermit.com

Handrails and guards capable of withstanding 200 lbs. applied in any direction at any point on the rail. (IBC 1607.8.1.1) Handrail at stairs with 4 or more risers. (R311.7.8) Handrail minimum 34" to maximum 38" above nose of tread to top of handrail. (R311. 7.8.1) Type I handrails with circular cross sections 1 1/4” - 2" diameter.

  Guard, Handrail, Handrails and guards

Smoke and carbon monoxide alarms must be provided in all ...

mybuildingpermit.com

• Smoke alarms and carbon monoxide alarms shall be located on every floor level, including basements (does not include crawlspace and uninhabitable attics). • In split level floor plans, at the upper level, provided there is no intervening door between adjacent levels and the lower level is less than a full story below the upper level

  Levels, Lamar

CONSTRUCTION TIP SHEET 19 Safety Glazing - …

mybuildingpermit.com

glass and safety glazing standard to which it complies. The label must be permanently etched, fired, or embossed, on the glass or be a type that once applied cannot be removed without being destroyed. Safety Glazing Required Locations: 1. Glazing in Doors: Safety glazing is required in fixed and operable panels of swinging, sliding, and bifold ...

  Glass, Etched

What are Deferred Submittals? - MyBuildingPermit

mybuildingpermit.com

design professional is required, shall list the deferred submittals on the construction documents for review by the building official. C. Generally, if an element has not been reviewed and approved under the original permit, it is required to be submitted as a deferred submittal to the City for review and approval.

  Under, Deferred