Transcription of 5. CMOS Operational Amplifiers - IMS
{{id}} {{{paragraph}}}
5. cmos Operational AmplifiersAnalog design for cmos vlsi SystemsFranco Maloberti5. cmos Operational Amplifiers1 analog design for cmos vlsi SystemsFranco MalobertiBasic op-ampThe ideal Operational amplifier is a voltage controlledvoltage source with infinite gain, infinite input impedanceand zero output op-amp is always used in feedback cmos Operational Amplifiers2 analog design for cmos vlsi SystemsFranco MalobertiTypical feedback configuration V0=V2Z4Z3+Z4Z1+Z2Z1 V1Z2Z1 The error due to the finite gain is proportional to 1 / A0. Thiserror must be smaller than the error due to impedancemismatch. V0=V2Z4Z3+Z4Z1+Z2Z1 V1Z2Z1 1+Z1+Z2A0Z1 Finite gain effect:5. cmos Operational Amplifiers3 analog design for cmos vlsi SystemsFranco MalobertiOTAIf impedances are implemented with capacitors andswitches, after a transient, the load of the op-amp is madeof pure capacitors.
Analog Design for CMOS VLSI Systems Franco Maloberti Input offset voltage: In real circuits if the two input terminals are set at the same voltage the output saturates close to VDD or to VSS. Input common mode range: It is the maximum range of the common-mode input voltage which do not produce a significant variation of the differential gain.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}