Transcription of 69-1714 - TH6110D Programmable Thermostat …
{{id}} {{{paragraph}}}
TH6110 DProgrammable ThermostatInstallationGuideFocusPRO TH6110D Programmable Thermostat1 Product ApplicationThis Thermostat provides electronic control of 24 VAC single-stage heating and cool-ing systems, or 750 mV heating Types Gas, oil, or electric heat with airconditioning Warm air, hot water, high-efficiencyfurnaces, heat pumps, steam, gravi-ty Heat only two-wire systems,power to open and close zonevalves (Series 20), and normally-open zone valves Heat only with fan Cool only 750 mV heating systemsPower Options Battery power only Common wire only Common wire with battery backupChangeover Options Selectable manual or auto-changeover modesSystem Settings Heat, Off, Cool,AutoFan Settings Auto, OnMust be installed by a trained, experienced technician Read these instructions carefully. Failure to follow these instructions can dam-age the product or cause a hazardous condition. Check the ratings in this booklet to verify that this product is suitable for yourapplication (see page 13).
in back of thermostat. 2 Pull wires through wire hole. 3 Position wallplate on wall,level and mark hole positions with pencil. 4 Drill holes at marked positions as shown below,then tap in supplied wall anchors. 5 Place wallplate over anchors,insert and tighten mounting screws. Insert finger into wire hole and pull to remove wallplate from ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}