Transcription of 7 Design and Operating Data - SEW-EURODRIVE
{{id}} {{{paragraph}}}
Example: dental hygienist
7 Design and Operating Data - SEW-EURODRIVE
7 TolerancesDesign and Operating Data111 Gear Units 201612345678910111213141516171819202122 Catalog7 Design and Operating heightsThe following tolerances apply to the indicated dimensions:Foot-mounted gear units: Check the motor diameter because it may project below themounting feet and require shimming below endsDiameter tolerance :Center bores according to DIN 332, shape D [in], shape DR [mm]:Keys: according to DIN shaftsDiameter tolerance :Spline shaftsFlangeCentering shoulder tolerance :Up to two different flange dimensions are available for each size of helical gear unit andSpiroplan gear unit.
• Observe the tolerances for dimension, D, in various areas along the shaft. • Refer to the dimension pages for the diameter and length of retaining screw [2]. • X must be > D. But the key does not have to extend the length of shaft. Figure 4: Customer shaft with contact shoulder [A] and without contact shoulder [B] [1] Hollow shaft [5 ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: