8500 Wall Mount Garage Door Opener Installation Manual

Please read this Manual and the enclosed safety materials carefully! Fasten the Manual near the Garage door after Installation . The door WILL NOT CLOSE unless the Protector System and cable tension monitor are connected and properly aligned. Periodic checks of the Garage door Opener are required to ensure safe operation. The model number label is located behind the hinged door of your Opener . DO NOT exceed 10 complete cycles of door operation per hour. This Garage door Opener is ONLY compatible with MyQ and Security+ product is intended for Installation only by trained Garage door technicians. This product may require adjustments to door springs and or track configurations. This product is not intended for use on low headroom tracks or Garage doors utilizing extension Residential and Light Duty Commercial Use Install On Sectional doors With Torsion Assemblies OnlySee Page 18 for DetailsWall Mount Garage Door OpenerModel 8500 LiftMaster 300 Windsor DriveOak Brook, IL 605232 IntroductionWhen you see these Safety Symbols and Signal Words on the

Preparing Your Garage Door BEFORE YOU BEGIN: • Disable locks. • Remove any ropes connected to the garage door. Complete the following test to make sure the garage door is balanced and is not sticking or binding: 1. Lift the door halfway up. Release the door. If balanced, it should stay in place, supported entirely by its springs. 2.

Tags:

  Your, Installation, Doors, Rope, Garage, Reopen, Garage door opener installation

Information