Transcription of 9 Common Wiring Mistakes and Code Violations
{{id}} {{{paragraph}}}
Example: air traffic controller
9 Common Wiring Mistakes and Code Violations
9 Whether to save time or money, lots of nonelectricians do electrical work. This is espe-cially true during the rough-in phase of new construction: drilling holes, running wire, and nailing up boxes. Remod-elers take on tasks as seemingly mundane as installing a new light fixture. As an electrical contractor, I ve hired many union and non-union electricians over the years, and most were horribly misinformed about the elec-trical trade and the building codes. If pro-fessionals have a hard time keeping up with important details, I imagine that carpenters and do-it-yourselfers are going to have a harder time. Before tackling electrical work, you should be aware of a few things. First, check with your local or state build-ing department to see what licenses or per-mits are required.
wiring system and cause a fire if improperly installed. 5. Don’t use wire runs as a clothesline. SOLUTION When running wire through a floor system, drill properly sized holes, or use a running board (photo far left) that’s at least a 1x4. Large runs of wire can be organized with raceways, a system of plastic clips (www ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: