Transcription of A5000GEC ZERO SPEED SWITCH - Maxigard™ Speed …
{{id}} {{{paragraph}}}
Example: bachelor of science
A5000GEC ZERO SPEED SWITCH - Maxigard™ Speed …
PCSPROCESS CONTROL SYSTEMSTMTMA5000 GECZERO SPEED SWITCHI ntroductionThe maxigard A5000 GEC is a zero SPEED SWITCH designed to monitor the starting andstopping of critical rotating shafts. Principle of OperationThe A5000 Series SPEED switches have a non contact sensor and is supplied with amagnetic target. The sensor signal is not impaired by the build up of dust or any otherforeign material on the magnetic target or sensor. This SWITCH is designed to detect zerospeed (speeds less than 1 RPM) of the monitored shaft. The A5000 GEC has two relay contacts. The relay is energized as soon as one magnetpasses in front of the sensor and remains energized until the monitored shaft SPEED dropsbelow 1 RPM for more than approximately seconds.
PCS PROCESS CONTROL SYSTEMS TM TM A5000GEC ZERO SPEED SWITCH Introduction The MAXIGARD A5000GEC is a zero speed switch designed to monitor the starting and
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: