Transcription of ANNEX SPECIFICATION FOR STRUCTURES TO BE …
{{id}} {{{paragraph}}}
Example: air traffic controller
ANNEX SPECIFICATION FOR STRUCTURES TO BE …
ANNEX . SPECIFICATION FOR STRUCTURES TO BE BUILT IN DISASTER AREAS. CHAPTER I - GENERAL PRINCIPLES. SCOPE. - Requirements of this SPECIFICATION shall be applicable to newly constructed buildings as well as to existing buildings. - Provisions to be applied for the prevailing buildings of which the intended use and / or carrier system shall be changed, the performance shall be evaluated before or after the earthquake and buildings to be strengthened were given in Section - 7. - Requirements of this SPECIFICATION shall be applicable to reinforced concrete (cast-in-situ and pre - stressed or non - pre - stressed prefabricated) buildings, structural steel buildings and building-like STRUCTURES , and timber, masonry and adobe buildings.
5 2.1. SCOPE 2.1.1 - Seismic loads and analysis requirements to be applied to the earthquake resistant design of all cast-in-site and prefabricated reinforced concrete buildings, structural steel buildings and building-like structures to be built in seismic zones defined in 1.2.3 are specified in this chapter.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
152 Earthquake Resistant Design According To, Standard CRITERIA FOR EARTHQUAKE, Standard CRITERIA FOR EARTHQUAKE RESISTANT DESIGN OF STRUCTURES, 1 GENERAL PROVISIONS AND BUILDINGS, EARTHQUAKE RESISTANT DESIGN, ECONOMICAL DESIGN OF EARTHQUAKE, Economical Design of Earthquake-Resistant, Analysis, Seismic Design, Earthquake, Design seismic, Document No. :: IITK-GSDMA-Wind05, Significant changes from the 2011