Transcription of ANNEX SPECIFICATION FOR STRUCTURES TO BE BUILT IN …
{{id}} {{{paragraph}}}
ANNEX . SPECIFICATION FOR STRUCTURES TO BE BUILT IN DISASTER AREAS. CHAPTER I - GENERAL PRINCIPLES. SCOPE. - Requirements of this SPECIFICATION shall be applicable to newly constructed buildings as well as to existing buildings. - Provisions to be applied for the prevailing buildings of which the intended use and / or carrier system shall be changed, the performance shall be evaluated before or after the earthquake and buildings to be strengthened were given in Section - 7. - Requirements of this SPECIFICATION shall be applicable to reinforced concrete (cast-in-situ and pre - stressed or non - pre - stressed prefabricated) buildings, structural steel buildings and building -like STRUCTURES , and timber, masonry and adobe buildings.
5 2.1. SCOPE 2.1.1 - Seismic loads and analysis requirements to be applied to the earthquake resistant design of all cast-in-site and prefabricated reinforced concrete buildings, structural steel buildings and building-like structures to be built in seismic zones defined in 1.2.3 are specified in this chapter.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
National Structural Steelwork Specification for, National Structural Steelwork Specification, OBSOLETE CANADIAN STRUCTURAL STEEL GRADES, Specification, Structural Steel, STRUCTURAL, Concealed Fastener Steel Roof and, Steel, Nucor Building Systems Specification Guide, Following Nucor Building Systems Specification Guide, REFERENCE STANDARD RS-10 STRUCTURAL, Reference Standard, REFERENCE STANDARD RS-10