Transcription of APPENDIX B: MATERIAL SETTINGS - Epilog Laser
{{id}} {{{paragraph}}}
Example: bachelor of science
APPENDIX B: MATERIAL SETTINGS - Epilog Laser
- 189 -Fusion Series Suggested MATERIAL SETTINGS (CO2) APPENDIX B: MATERIAL SETTINGSF usion Series Suggested MATERIAL SETTINGS (CO2) watt40 watt50 watt60 watt75 watt120 wattAcrylicPhoto Engraving300 DPI90s 60p90s 55p90s 50p90s 45p90s 40p90s 30pText/Clipart Engraving300 DPI90s 80p90s 75p90s 70p90s 65p90s 60p90s 55pText/Clipart Engraving600 DPI90s 75p90s 70p90s 65p90s 60p90s 55p90s 50pCutting 1/8 (3 mm)100 f5s 100p6s 100p7s 100p8s 100p10s 100p12s 100pCutting 1/4 (6 mm)100 f2s* 100p3s* 100p 1s 100p2s 100p3s 100p7s 100pCutting 3/8 ( mm)100 f2s* 100p3s* 100p 1s 100p3s 100pCutting 1/2 (13 mm)100 f1s 100pCutting Note: Adjusting the standard focus distance so it is closer to the lens by about .080 (2 mm) will produce better edge quality when cutting 1/4 (3mm) acrylic and thicker. Two passes can be used for cutting thicker materials. There are two types of acrylic: cast is better for engraving (it creates a frosted look when engraved) and extruded acrylic produces a much better flame polished edge.
laser out of focus by +.06” - .09” broadens the beam and produces a very bright mark on anodized coating. Lower frequency and higher power …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: