Transcription of APPENDIX B: MATERIAL SETTINGS - Epilog Laser
{{id}} {{{paragraph}}}
Example: bachelor of science
APPENDIX B: MATERIAL SETTINGS - Epilog Laser
- 189 -Fusion Series Suggested MATERIAL SETTINGS (CO2) APPENDIX B: MATERIAL SETTINGSF usion Series Suggested MATERIAL SETTINGS (CO2) watt40 watt50 watt60 watt75 watt120 wattAcrylicPhoto Engraving300 DPI90s 60p90s 55p90s 50p90s 45p90s 40p90s 30pText/Clipart Engraving300 DPI90s 80p90s 75p90s 70p90s 65p90s 60p90s 55pText/Clipart Engraving600 DPI90s 75p90s 70p90s 65p90s 60p90s 55p90s 50pCutting 1/8 (3 mm)100 f5s 100p6s 100p7s 100p8s 100p10s 100p12s 100pCutting 1/4 (6 mm)100 f2s* 100p3s* 100p 1s 100p2s 100p3s 100p7s 100pCutting 3/8 ( mm)100 f2s* 100p3s* 100p 1s 100p3s 100pCutting 1/2 (13 mm)100 f1s 100pCutting Note: Adjusting the standard focus distance so it is closer to the lens by about.
- 191 - APPENDIX B: MATERIAL SETTINGS Fusion Series Suggested Material Settings (CO2) • These are only suggestions: Every type of material will react differently with the laser, even from one plastic to the next. Use these settings as your starting point then adjust one variable at a time until you achieve the result you desire.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: