ASME B31.3 Process Piping - psig.sg

asme Process Piping Course7. Layout and SupportBECHTENGINEERING COMPANY, and Support -1 asme Process PipingCharles Becht IV, PhD, PE Don Frikken, PEInstructorsBECHTENGINEERING COMPANY, and Support -21. Establish applicable system standard(s)2. Establish design conditions3. Make overall Piping material decisions Pressure Class Reliability Materials of construction4. Fine tune Piping material decisions Materials Determine wall thicknesses Valves5. Establish preliminary Piping system layout & support configuration6. Perform flexibility analysis7. Finalize layout and bill of materials8. Fabricate and install9. Examine and testPiping Development ProcessASME Process Piping Course7. Layout and SupportBECHTENGINEERING COMPANY, and Support -37. Layout and Support General Considerations Support Spacing Support Locations Support ElementsBECHTENGINEERING COMPANY, and Support -4 The Material in This Section is Addressed by in:Chapter II - DesignASME Process Piping Course7.

ASME B31.3 Process Piping Course 7. Layout and Support BECHT ENGINEERING COMPANY, INC. Layout and Support -13 Support Spacing S L = (wL2 + 2HL) / (8Z) + PD/4t Where D = pipe outside diameter

Loading..

Tags:

  Process, Asme, Piping, Asme b31, 3 process piping

Information