Transcription of Assembly Instructions for compression gland - …
{{id}} {{{paragraph}}}
Example: biology
Assembly Instructions for compression gland - …
IIIA rmour/braidShroud optionNote:Tape armour must be re-trimmed at 90 to the vertical axis of the cableafter it has been spread,to ensure that the full face is correctly Type: 453/RAC Exd I Mb / Exe I MbBaseefa08 ATEX0331X IM2 IP66 IECEx DetailsOperating temperature range -60 C +80 OfficeOxford Street West,Ashton-Under-Lyne,Lancashire. OL7 0NA. UKSales: +44 (0) 161 830 6698 Technical: +44 (0) 161 830 6697 Fax: +44 (0) 161 830 6648E-mail: SolutionsHawke International is a division of Hubbell No. 669157 in England. Registered Office:Cannon Place, 78 Cannon Street, London EC4N 383 - Issue B / Page 1 of 2A member of the Hubbell Group of CompaniesAI 383 / Issue B - 03/16 Assembly Instructions for compression gland for mining applications: 453/RAC Exd I Mb, Exe I MbBraid 'X',Flat Steel Wire 'Y',Steel Tape 'Z'Ring PositionSWAP ositionGeneral identification ring orientation for:Reversible Armour Clamping Ring (RAC)IMPORTANT: The arrowhead indicatingthe correct armour thickness or typeshould point towards the equipmentNote: Cable acceptance sizes are marked on the diaphragm seal, clamping ring and Cable to suit equipment as shown above andexpose the armour/braid 'I'.
II I Armour/braid Shroud option Note: Tape armour must be re-trimmed at 90° to the vertical axis of the cable after it has been spread, to ensure that the full
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: