Ball bearing units and insert bearings - SKF

A supplement to SKF bearings and mounted products (pub #100-700) ball bearing units and insert bearingsTABLE OF CONTENTSBall bearing units bearing units ..2 Shaft locking methods ..4 Seal and flinger options ..5 ball bearing unit radial load charts ..6 Air handling units ..8 ball bearing units ..10 insert bearings bearings nomenclature ..44 Speed ratings / Internal bearings ..46 This catalog is intended to be used as a product reference guide only and as such contains only very basic information. This catalog is not intended to be used as a design manual. The data in this catalog is based on current information at the time of press. SKF reserves the right to make changes necessitated by technological developments.

bearings, initial errors in alignment should not ex-ceed ±2° for basic bearings size 211 and smaller and ±1.5° for larger sizes. Misalignment greater than this will prevent the lubrication holes in the outer ring of the bearing from lining up with the groove in the housing bore, and the bearings will also not be relubricated. Grease fill

Tags:

  Unit, Bearing, Ball, Ball bearing units and insert bearings, Insert

Information

Related search queries