Transcription of Basic Cisco Commands - Weber State University
{{id}} {{{paragraph}}}
Example: dental hygienist
Basic Cisco Commands - Weber State University
Basic Cisco Commands By Marcus Nielson (2014) Configuring Basic Switch Settings (Switch Examples) Enter enable if the prompt has changed back to Switch>. Switch> enable Switch# Enter global configuration mode. Switch# configure terminal Enter configuration Commands , one per line. End with CNTL/Z. Switch(config)# The prompt changed again to reflect global configuration mode. Assign the switch hostname. Switch(config)# hostname S1 S1(config)# Configure password encryption. S1(config)# service password-encryption S1(config)# Assign class as the secret password for privileged EXEC mode access. S1(config)# enable secret class S1(config)# Prevent unwanted DNS lookups.
R3(config-ext-nacl)# permit tcp 192.168.30.0 0.0.0.255 209.165.200.224 0.0.0.31 eq 80 R3(config-ext-nacl)# interface S0/0/1
Loading..
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: