Transcription of BASIC ELECTRONIC COMPONENTS - Robotshop
{{id}} {{{paragraph}}}
BASIC ELECTRONIC COMPONENTSMODEL ECK-10 Instruction Manualby Arthur F. Seymour MSEEIt is the intention of this course to teach the fundamental operation of basicelectronic COMPONENTS by comparison to drawings of equivalent mechanicalparts. It must be understood that the mechanical circuits would operate muchslower than their ELECTRONIC counterparts and one-to-one correlation can neverbe achieved. The comparisons will, however, give an insight to each of thefundamental ELECTRONIC COMPONENTS used in every ELECTRONIC , 2004, 1994 ElencoTMElectronics, 2004 REV-G 753254 ResistorsCapacitorsCoilsSemiconductorsOt hersTransformers-1-RESISTORSRESISTORS,Wh at do they do?The ELECTRONIC component known as the resistor isbest described as electrical friction.
rod (see Figure 3). The rod was usually made of some form of ceramic that had the desired heat properties since the wires could become quite hot during use. End caps with leads attached were then placed over the ends of the rod making contact to the resistive wire, usually a nickel chromium alloy. The value of wirewound resistors remain fairly flat
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}