Transcription of BASIC OPERATION AND FUNCTION OF CONTROL VALVES
{{id}} {{{paragraph}}}
Example: air traffic controller
BASIC OPERATION AND FUNCTION OF CONTROL VALVES
BASICBASICOPERATIONOPERATIONANDANDFUNCTI ONFUNCTIONOFOFCONTROLCONTROLVALVESVALVES 02-99- 2 -That valvedrives me crazy!??What ishappening insidethat valve??Gaskets Won't Seal!Unusually HighTrim Maintenance!!Packing Always Leaks!NOISY!!VIBRATING!!Positioner AlwaysNeeds Calibration!Too much seat leakage!LOUSY CONTROL !RATTLING!Table of ContentsTOPIC - SUBJECTSECTIONT erminology------------------------------ -------------------------------- 1 CONTROL Valve BASIC Designs --------------------------------------- 2 Characterization and Trim Design -------------------------------- 3 CONTROL Valve Technical Considerations ----------------------- 4 Force-Balance Principle ---------------------------------------- ----- 5 actuator BASIC Designs ---------------------------------------- ------ 6 CONTROL Valve Unit Action ---------------------------------------- --- 7 actuator Benchset Range ---------------------------------------- --- 8 Valve Positioner Basics ---------------------------------------- ------ 9 CONTROL Loop Action ---------------------------------------- ---------- 10 CONTROL Valve Packing Designs ----------------------------------- 11 Seat Leakage ---------------------------------------- -------------------- 12- 3 -SECTION 1 Terminology- 4 - CONTROL VALVE
actuator: An actuator is a pneumatic hydraulic, or electrically powered device which supplies force and motion to open or close a valve. airset: A regulator which is used to control the supply pressure to the valve actuator and its auxiliaries. angle valve: A valve design in which one port is collinear with the valve stem or actuator, and the other
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: